MathGroup Archive 2000

[Date Index] [Thread Index] [Author Index]

Search the Archive

Re: using the result from previous calculation

  • To: mathgroup at smc.vnet.net
  • Subject: [mg26225] Re: [mg26223] using the result from previous calculation
  • From: "Mark Harder" <harderm at ucs.orst.edu>
  • Date: Wed, 6 Dec 2000 02:16:14 -0500 (EST)
  • Sender: owner-wri-mathgroup at wolfram.com

Robert-
    You need to name your results.  Give different results different names,
i.e. x=result1;  y=result2;  , etc.    If the result is a list & you need
specific elements, you refer to them with Part[list,n], or list[[n]], which
is the same thing.  You would probably benefit from reading any of the
introductory books about Mathematica to get this sort of thing and more
details.
-mark harder


-----Original Message-----
From: Robert Koppensteiner <koppensteiner.robert at utanet.at>
To: mathgroup at smc.vnet.net
Subject: [mg26225] [mg26223] using the result from previous calculation


>Hi to all,
>
>I am a newbie to Mathematica having the following question: When I want
>to use in a programm the previous result (and depending on parameters)
>there have been more than one - and getting a result list - how could I
>use the first one for the following calculations ?
>
>thanks,
>robert.
>
>
>



  • Prev by Date: Re: Volumes
  • Next by Date: Re: using the result from previous calculation
  • Previous by thread: Re: using the result from previous calculation
  • Next by thread: Re: using the result from previous calculation