Re: combining graphics
- To: mathgroup at smc.vnet.net
- Subject: [mg24327] Re: combining graphics
- From: Jens-Peer Kuska <kuska at informatik.uni-leipzig.de>
- Date: Sun, 9 Jul 2000 04:52:36 -0400 (EDT)
- Organization: Universitaet Leipzig
- References: <8k3lbq$3ko@smc.vnet.net>
- Sender: owner-wri-mathgroup at wolfram.com
Hi,
this was ask one million times before and
the answer is always the same
Block[{$DisplayFunction = Identity},
a = Plot[x, {x, 0, 1}];
b = Plot[2 x, {x, 0, 1}]
]
Show[a, b];
Regards
Jens
Robert wrote:
>
> how can i omit the plot of curves before combining them with Show[.]?
>
> e.g.
>
> a=Plot[x,{x,0,1}];
> b=Plot[2 x,{x,0,1}];
> Show[a,b];
>
> the output on the screen gets rather complex if a lot of
> Plot[.]-commands are used and since i'm only interested in the final
> Show[.]-output, i'd like to omitt the rest, is there a way to do this?
>
> thanks, robert