MathGroup Archive 2003

[Date Index] [Thread Index] [Author Index]

Search the Archive

Re: signal detector question

  • To: mathgroup at smc.vnet.net
  • Subject: [mg39633] Re: signal detector question
  • From: "Kevin J. McCann" <kjm@KevinMcCann>
  • Date: Thu, 27 Feb 2003 00:27:08 -0500 (EST)
  • References: <b3hs60$ikb$1@smc.vnet.net>
  • Sender: owner-wri-mathgroup at wolfram.com

Although it is sometimes possible to "see" the signal from a pileup, it is
not usually detectable from the signal itself. There are a couple of things
to look at. First, you should look at the width of the PMT signal to see the
maximum number of distinguishable pulses you could handle per second say
1/(2*pulsewidth). If you are approaching this count rate you can bet that
you are getting pileup. I don't know your application, but if you can put a
selection of neutral density filters in to reduce the photon count, then you
should see

        (count rate) * 10^ND ~= constant

If pileup is occuring, then you will see a deviation from this for low ND
(lots of photons).

Hope this helps.

Kevin J. McCann

"The Leddons" <jleddon1 at attbi.com> wrote in message
news:b3hs60$ikb$1 at smc.vnet.net...
>
> Hi,
> Does anyone know of an example of pulse pile up and how it is detected
> in a data set? This is when two photons or particles hit a detector at
> the same time and get counted as one particle/or photon. Is there a way
> to uncover this problem in a residuals analysis of the data distribution
> for example? Would appreciate an example notebook.
>
> Thanks if you guys can help.
> Debi-lyn
>
>




  • Prev by Date: Re: Domain of Sin[ArcSin[x]] ?
  • Next by Date: RE: Domain of Sin[ArcSin[x]] ?
  • Previous by thread: signal detector question
  • Next by thread: Re: signal detector question