       Re: 3D plot question

• To: mathgroup at smc.vnet.net
• Subject: [mg62631] Re: 3D plot question
• From: "Jens-Peer Kuska" <kuska at informatik.uni-leipzig.de>
• Date: Wed, 30 Nov 2005 00:06:08 -0500 (EST)
• Organization: Uni Leipzig
• References: <dmh8kd\$8nm\$1@smc.vnet.net>
• Sender: owner-wri-mathgroup at wolfram.com

```Hi,

a surface has the tickness zero -- otherwise it is
no surface.

Regards
Jens

"Tun Myint Aung" <tma at nus.edu.sg> schrieb im
Newsbeitrag news:dmh8kd\$8nm\$1 at smc.vnet.net...
|
| Dear MathGroup,
|
|    I have found the solution. Use
PlotRange->All. Another question is
| that how I can plot to see the thickness of the
surface?
|
| With Regards,
|
| Tun Myint Aung
|
|  _____
|
| From: Tun Myint Aung
To: mathgroup at smc.vnet.net
| Subject: [mg62631] 3D plot question
|
|
| Dear Mathgroup,
|
|    When I plot a 3D plot in mathematica, I found
that some part of the
| surface has been cut off in the graph. For
example,
|
|    z = x^5*y
|
|    Plot3D[z, {x, -1, 1}, {y, -1, 1},
PlotPoints -> 40,
|
| Mesh -> False, BoxRatios -> {1, 1, 0.4}]
|
| Mathematica plot for z values only in the
range -0.2 to 0.2. Actually
| when x=1, y=1, z value will be 1. But in the
graph, the surface goes
| flat for z>0.2.Why? How can I get the graph for
full range of z?
|
|
|
| Best Regards,
|
| Tun Myint Aung
| National University of Singapore
| E1A #02-18
| Kent Ridge, 119260, Singapore
| E-mail g0202015 at nus.edu.sg
<mailto:g0202015 at nus.edu.sg>
|
|

```

• Prev by Date: Re: Built-In fuctions redefined---How?
• Next by Date: Re: Notebook for Borel-Tanner Distribution
• Previous by thread: Re: 3D plot question
• Next by thread: Re: Re: FW: 3D plot question