Re: 3D plots

• To: mathgroup at smc.vnet.net
• Subject: [mg67294] Re: 3D plots
• From: "qfwfq" <qfwfq_0 at yahoo.com>
• Date: Fri, 16 Jun 2006 00:27:24 -0400 (EDT)
• References: <e6lhha\$ndi\$1@smc.vnet.net><e6oovb\$rt9\$1@smc.vnet.net>
• Sender: owner-wri-mathgroup at wolfram.com

Hi Jens,

Thanks for your response. I've sent to the list a piece of the list I
try to represent.
I will try your proposal.

Thanks

Jose

Jens-Peer Kuska ha escrito:

> Hi,
>
> how do you expect to build a solid form {x_coord,
> y_coord, z_min, z_max} ??
> You can use the TriangularSurfacePlot[] function
> form the DiscreteMath`ComputationalGeometry`
> package and draw the surface from the {x,y,zmin}
> and {x,y,zmax} values
> and compute the convex hull of the {x,y} pairs to
> construct the
> surfaces that close the top and bottom surface.
>
> Regards
>   Jens
>
> "qfwfq" <qfwfq_0 at yahoo.com> schrieb im Newsbeitrag
> news:e6lhha\$ndi\$1 at smc.vnet.net...
> | Hi!
> |
> | I would like to build a 3D graphics from a list
> of data. Each element
> | from the list has 4 components: {x_coord,
> y_coord, z_min, z_max}, i.e.,
> | something like to vertical lines for each point
> in the x-y plane.
> | Is there any simple way to graphically draw the
> corresponding solid?
> |
> | Thanks.
> |
> | Jose
> |

• Prev by Date: Unexpected condition on convergence of integral
• Next by Date: Re: 3D plots
• Previous by thread: RE: 3D plots
• Next by thread: Re: 3D plots