Re: a little more complex list operation
- To: mathgroup at smc.vnet.net
- Subject: [mg40247] Re: a little more complex list operation
- From: rolf at mertig.com (Rolf Mertig)
- Date: Fri, 28 Mar 2003 04:28:20 -0500 (EST)
- References: <b5uoth$lks$1@smc.vnet.net>
- Sender: owner-wri-mathgroup at wolfram.com
One way is to use "@@@" :
In[1]:= data = {{x1,y1},{x2,y2},{x3,y3}};
In[2]:= {f[#1],g[#2]}&@@@data
Out[2]= {{f[x1], g[y1]}, {f[x2], g[y2]}, {f[x3], g[y3]}}
Rolf Mertig
Mertig Consulting
http://www.mertig.com
Nathan Moore <nmoore at physics.umn.edu> wrote in message news:<b5uoth$lks$1 at smc.vnet.net>...
> Thanks very much for all the previous replies. Another simple question -
> though I guess this will require more complex syntax. Suppose I have the
> list,
>
> data = {{x1,y1},{x2,y2},{x3,y3}}
>
> and I want to produce the result (for fitting/plotting)
>
> data2 = {{f[x1],g[y1]},{f[x2],g[y2]},{f[x3],g[y3]}}
>
> I assume that if there was only one transform I wanted to apply, f[x],
> then I could say
> data2 = f[data]
> but how about this more complicated transform with functions f and g?
>
> again thanks! Your replies have been very helpful!
>
> Nathan Moore, University of Minnesota Physics