Services & ResourcesWolfram ForumsMathGroup Archive

[Date Index] [Thread Index] [Author Index]

Limiting Output Based on Z Axis of Plotd3d[Evaluate@Table[PDF[NormalDistribution

• To: mathgroup at smc.vnet.net
• Subject: [mg130538] Limiting Output Based on Z Axis of Plotd3d[Evaluate@Table[PDF[NormalDistribution
• From: Garrett Fisher <fisher.garrett at gmail.com>
• Date: Fri, 19 Apr 2013 01:18:47 -0400 (EDT)
• Delivered-to: l-mathgroup@mail-archive0.wolfram.com
• Delivered-to: l-mathgroup@wolfram.com
• Delivered-to: mathgroup-newout@smc.vnet.net
• Delivered-to: mathgroup-newsend@smc.vnet.net

Good Day,

I am plotting some bell curves using the function in the subject line.
The PDF of NormalDist produces static Z values - which is fine -
except I wish to limit them. I would like to show XY data at Z 0, 10,
20, 30 and so forth - with an intended gap in the Plot for Z 1-9,
11-19, 21-29. I am beginning to think that getting into the actual
data output of the Table might be necessary. I am fine with that - I
am just a bit new at Mathematica - so I don't know where to start to
figure that part out.

Thanks for any help!!!

• Follow-Ups:
  • Re: Limiting Output Based on Z Axis of Plotd3d[Evaluate@Table[PDF[NormalDistribution
    • From: Bob Hanlon <hanlonr357@gmail.com>